Procom MH 1-LXR User Manual
Page 2
INSTALLATION
The LX-mount is especially suited for roof-mounting. It is recommended to
mount the antenna at the centre of the roof to ensure the best
omnidirectional coverage. Mounting can take place in an 18 mm dia. hole
with access from the outside only. When cleaning the car in car-washing
machines, the whip should be removed – a 9 mm fork spanner can be used.
After wash, the whip is refitted and tightened lightly with the spanner.
The mount is equipped with a bendable section (±15°) to make it possible
to adjust the antenna to an upright position.
1. INSTALLATION DIMENSIONS
2. INSTALLATION STEPS
Do not use sealer on rubber gasket or other places.
PLEASE NOTE:
When tightening the revolving nut (see picture 4), special care must be
taken to keep the spanner in the correct position.
3. TUNING / MODEL CONVERSION
The antenna should always be tuned using an SWR-meter.
The cutting diagrams below serve as a guide for this procedure.
PROCOM A/S reserve the right to amend specifications
without prior notice.
07/04/11