Procom PRO-phy150-2 - Manual

PRO-PHY150-2
2-Channel Hybrid Ring Combiner for 150 MHz Transmitters
DESCRIPTION
Combining two transmitters or receivers on the same antenna.
Better utilization of good antenna position.
Two antennas on the same transmitter or receiver.
Combining two signal generators.
The only combining option with very small TX-TX frequency spacing.
60 W load supplied (other loads or no load as option).
ORDERING DESIGNATIONS
TYPE PRODUCT NO. FREQUENCY
PRO-PHY150-2-1 210000538 136 - 142 MHz
PRO-PHY150-2-2 210000878 140 - 146 MHz
PRO-PHY150-2-3 210000590 144 - 150 MHz
PRO-PHY150-2-4 210000544 148 - 154 MHz
PRO-PHY150-2-5 210000571 152 - 158 MHz
PRO-PHY150-2-6 210000572 156 - 162 MHz
PRO-PHY150-2-7 210000537 160 - 166 MHz
PRO-PHY150-2-8 210000545 164 - 170 MHz
PRO-PHY150-2-9 210000548 168 - 174 MHz
PRO-PHY150-2-10 210000629 172 - 178 MHz
SPECIFICATIONS
ELECTRICAL
FILTER TYPE Hybrid Ring Junction
FREQUENCY 136 - 175 MHz (see table)
MAX. INPUT POWER 50 W per channel
(max. 150 W with larger load)
INSERTION LOSS < 3.3 dB @ 3 MHz BW
< 3.5 dB @ 6 MHz BW
ISOLATION TX 1 -TX 2
(*see note)
> 35 dB @ 3 MHz BW
> 30 dB @ 6 MHz BW
IMPEDANCE Nom. 50 Ω
LOAD (**see note) 60 W load fitted (other ratings available)
SWR < 1.5 with all other ports terminated with 50
MECHANICAL
TEMP. RANGE –30° C → +60° C
CONNECTORS N-female (other types as option)
DIMENSIONS (L x W x H) 216 x 89 (incl. conn.) x 42 mm (excl. load)
WEIGHT Approx. 700 g (excl. load)
*The isolation between the TX ports is directly dependent on the terminating
SWR on the antenna port. With an antenna load SWR = 1.5, the isolation
between the two TX ports will be reduced to 20 dB @ 3 MHz bandwidth.
**The SWR of the load’s should be < 1.1! The load should be able to
dissipate 1/2 of the total input power.
E.g.: With 50 W input in total for the two channels, the load should be able
to dissipate 50 W x 1/2 = 25 W.
TYPICAL RESPONCE CURVE
PROCOM A/S reserve the right to amend specifications
without prior notice.
31/10/11