Procom MU 904-x-... - Manual (Page 2)

INSTALLATION
This antenna should be mounted on the car roof to ensure best
omnidirectional coverage.
Mounting can take place exclusively with access from the outside when
drilling an 18 mm dia. hole. Mounting can take place from the inside by
drilling a 14 mm dia. hole. When mounting in a 14 mm dia. hole, remove the
bottom plastic ring of the packing gasket with a sharp cutter.
When cleaning the car in car-washing machines, remove the whip using a
spanner, size 9 mm. After wash, refit the whip and tighten it lightly with the
spanner.
As the X- and CX-mounts are internally equipped with a bendable section,
the antenna can always be adjusted to an upright position independent of
the tilt angle of the installation spot (up to 30° tilt).
The MiniMag (abbreviated: MM) is a small, light-weight magnetic mount with
a high attaching effect. A silicone layer applied to the contact surface
protects the car roof and ensures maximum friction.
Antennas with magnetic mount should be mounted at the centre of the
vehicle roof to ensure best omnidirectional coverage.
1. INSTALLATION DIMENSIONS
2. INSTALLATION STEPS
Do not use sealer on rubber gasket or other places.
3. TUNING
The antenna is delivered factory-tuned and requires no further tuning.
PLEASE NOTE
For safety reasons
When using the MU 904-MM/…, car speed must not exceed 1.
150 km/h.
If operating the MM-mount with other whips, whip length must never
2.
exceed 320 mm, and utilizing this maximum length, car speed must
not exceed 115 km/h.
PROCOM A/S reserve the right to amend specifications
without prior notice.
15/12/11