Procom LH 108-136-amp User Manual
Procom Accessories communication
LH 108/136 AMP
Diplexer for Mobile Telephone (136 - 1300 MHz) and Car
Radio (0 - 108 MHz) with built-in low-noise amplifier
DESCRIPTION
Diplexer for simultaneous operation of mobile telephone and car radio
on a common mobile radio antenna.
A single diplexer covers all communication bands 136 - 1300 MHz.
Built-in low-noise SMD-equipped amplifier in the car radio section gives
freedom of choice of mobile telephone antenna.
Better reception of car radio signals due to the built-in low-noise
amplifier.
Power supply of the low-noise amplifier via the car radio cable or by
direct wiring.
Extremely compact.
Quick installation using dual-adhesive pad provided.
FME-connections on antenna and mobile telephone terminals
CRC connection (M10 x 0.75) on the car radio terminal.
Power supply 12 V to the low-noise amplifier via CRC-connection.
Procom 75 Ohm car radio cable available as an option.
ORDERING DESIGNATIONS
TYPE
PRODUCT NO.
LH 108/136 AMP
200000768
SPECIFICATIONS
ELECTRICAL
MODEL
LH 108/136 AMP
FREQUENCY
Mobile telephone: 136 – 1300 MHz
Car radio : 0 - 108 MHz
MAX. INPUT POWER
35 W
INSERTION LOSS
0 - 108 MHz : ~ +7 dB Gain
136 - 175 MHz : ≤ 0.8 dB
175 - 1300 MHz : ≤ 0.3 dB
ISOLATION
RADIO to COM
≥ 40 dB typ. ≥ 45 dB
> 38 dB at 108 and 136 MHz
IMPEDANCE
COM : 50 Ω, SWR < 1.5
Radio : 75 Ω
POWER SUPPLY
+12 V from the car via CRC-connection
or directly
POWER CONSUMP.
~ 25 mA
MECHANICAL
TEMP. RANGE
–30° C → +70° C
CONNECTORS
Antenna : FME
COM : FME
Radio: CRC-Connector (M10 x 0.75)
DIMENSIONS (W x H x D)
50 x 21 x 60 mm
WEIGHT
Approx. 73 g
ACCESSORIES
Car radio cable
Type 1 m CRC (length 1 m)
Type 5 m CRC (length 5 m)
TYPICAL RESPONSE CURVES
INSTALLATION NOTES
The 50 Ω cable between antenna and diplexer should be kept as
1.
short as possible (preferably not over 1 m).
Some communication antennas have insufficient height to ensure
2.
satisfactory broadcast reception. Only antenna whips with a height of
at least 25 cm are acceptable.
Tuning: The antenna is tuned for best SWR at the operating
3.
frequency as usual. The filter is factory-tuned and ready for
installation. The car radio is tuned for optimum reception on the MW-
band by means of the antenna tuning screw (if present).
PROCOM A/S reserve the right to amend specifications
without prior notice.
21/09/12