beautypg.com

Procom GF 27 User Manual

Page 2

background image

INSTALLATION

1. BEFORE INSTALLATION

When selecting mounting location take into consideration: positions of

back view mirror, wiper blade paths and defogger wires (when mounting

on rear window). The driver’s view should not be obstructed.
Environmental- and car temperature must be above 15° C at installation,

and surfaces to be glued must be dry and clean.

2. INSTALLATION

3. AFTER INSTALLATION

Allow the silicone gluings to dry off 2 hours at a temperature above 15°

C. To ensure full strength of the glue, it is recommended to keep the

whip off the mount for 24 hours.

4. TUNING INSTRUCTIONS

Insert an SWR-meter between the transmitter and the antenna.
Key the transmitter on ch. 1 and measure SWR.
Remove the rubber top. Cut off the top end of the whip (approx. 1 cm

at a time) until SWR is minimum.
Key the transmitter on ch. 20. Cut off the top end of the whip (approx. 5

mm at a time) until SWR is minimum.
Fit the rubber top. Tuning is completed.

REINSTALLATION KIT

A reinstallation kit including all necessary parts for transfer of the antenna to

another vehicle is available under order No. »GF-RK«.

WARNING

SAFETY PRECAUTIONS

Antennas mounted on the windscreen may cause relatively high field

strengths in the passenger cabin and near the dashboard.

To prevent health hazard due to RF radiation, persons must not be

1.

closer than

30 cm to the antenna whip (transmitter output power to the matching

unit:

20 W). (DIN 57 848).
The RF signals at the dashboard may cause interference in the car’s

2.

electronic equipment such as broadcast radio, computer automatics,

braking systems, electronic ignition, relays etc. Some cars are more

susceptible to disturbances than others.

It is the responsibility of the installer to carry out a thorough check of

the proper functioning under any conditions of such circuits before

finishing installation.

The enclosed silicone adhesive contains acetic acid and fungicides. Keep out

of reach of children and dispose properly.

PROCOM A/S reserve the right to amend specifications

without prior notice.
12/04/11