Procom GPS-C HX 2-... - Manual

GPS-C HX 2/...
GPS Antenna with a ¼ λ Helical Antenna for the 160 MHz
Band
DESCRIPTION
External antenna whip mounted on the GPS-Combi mount.
Flexible, conical steel helix moulded in flexible thermoplastic
rubber.
Reduced-size ¼ λ helical antenna whip.
Easily removable whip for car wash.
GPS-antenna for fixed installations.
Full hemispherical coverage.
Built-in high gain, low noise amplifier.
Right-Hand Circularly Polarized antenna (RHCP).
5 V supply voltage (3 V respectively 12 V available on request).
DC supply via RF-connector.
ORDERING DESIGNATIONS
TYPE PRODUCT NO.
GPS-C HX 2/... 132000049
When ordering, please state the required frequency (144 – 175 MHz).
SPECIFICATIONS FOR WHIP
ELECTRICAL
MODEL GPS-C HX 2/...
ANTENNA TYPE Shortened ¼ λ helical antenna
FREQUENCY Tunable by cutting within: 144 – 175 MHz
IMPEDANCE Nom. 50 Ω
POLARIZATION Vertical
GAIN Approx. -3 dB (acc. to EIA RS-329-1)
MAX. POWER 10 W
MECHANICAL
MATERIALS Steel helix moulded in flexible thermoplastic rubber
Black-chromed brass
COLOUR Black
HEIGHT Approx. 130 mm (dep. on freq.)
WEIGHT Approx. 34 g (dep. on freq.)
MOUNTING On the GPS-Combi mount
SPECIFICATIONS FOR GPS-COMBI MOUNT
ELECTRICAL GENERAL SPECIFICATIONS
MODEL GPS-COMBI MOUNT
ANTENNA TYPE Active patch antenna
FREQUENCY 1575 MHz
IMPEDANCE Nom. 50 Ω
POLARIZATION Circular right-hand
COVERAGE Hemispherical
GAIN 28 dBic in axial direction (typ.)
CROSS-
POLARIZATION ATT.
> 10 dB (typ.)
SELECTIVITY > 45 dB down @ ± 45 MHz
BUILT-IN AMPLIFIER
GAIN > 30 dB (typ.)
NOISE FIGURE < 1 dB (typ.)
P 1dB
Approx. +7 dBm
SWR (output) ≤ 2.0
SUPPLY VOLTAGE 5 ± 0.5 VDC (3 V resp. 12 V on request)
CURRENT
CONSUMPTION
Approx. 25 mA
MECHANICAL (ONLY FOR THE GPS-PART)
MATERIALS Cu-nite brass
Stainless steel
Reinforced thermoplastic
ANTENNA COLOUR Black
TEMP. RANGE -35° C →+75° C
CONNECTOR FME (male for GPS) +
FME (female for mobile antenna)
RECOMMENDED
INSTALL. TORQUE
4 ± 0.5 Nm
DIMENSIONS (H x L) Approx. 30 x 89 mm
ROOF THICKNESS Max. 2.5 mm
WEIGHT Approx. 114 g
MOUNTING ø18.0 mm dia. hole for roof thickness up to 2.0 mm
ø18.5 mm dia. hole for roof thickness 2.0 - 2.5 mm
Tools for mounting included