Procom MU 1-lx-... User Manual
Page 2
INSTALLATION
The LX-mount is especially suited for roof-mounting. It is recommended to
mount the antenna at the centre of the roof to ensure the best
omnidirectional coverage. Mounting can take place in an 18 mm dia. hole
with access from the outside only.
When cleaning the car in car-washing machines, the whip should be
removed – a 9 mm fork spanner can be used. After wash, the whip is
refitted and tightened lightly with the spanner.
The mount is equipped with a bendable section (±15°) to make it possible
to adjust the antenna to an upright position.
1. INSTALLATION DIMENSIONS
2. INSTALLATION STEP
Do not use sealer on rubber gasket or other places.
PLEASE NOTE
When tightening the revolving nut (see picture 4), special care must betaken
to keep the spanner in the correct position.
3. TUNING/MODEL CONVERSION
The antenna is delivered factory-tuned and requires no further tuning.
To convert an MU 1-LX/s model into an MU 1-LX/l model, cut off 13 mm of
the top end of the whip.
To convert an MU 1-LX/l model into an MU 1-LX/h model, cut off 13 mm of
the top end of the whip.
PROCOM A/S reserve the right to amend specifications
without prior notice.
02/12/11