beautypg.com

Procom MZG User Manual

Page 2

background image

USING THE MZG

This magnetic mount is used to make an occasional antenna installation

where it is not desirable to drill holes in the mobileunit.

A magnetic mount antenna can advantageously serve several mobile units

by shifting it from one unit to another.

The MZG is provided with a large-diameter, thoroughly magnetized

permanent ring magnet positioned in a carefully shapedmagnetic circuit

which yields an extraordinarily high attaching effect. The further extension

of the supporting surface beyondthe magnet area makes this mount stand

for astounding values of bending moment and mechanical shock.

The low profile of the MZG ensures low wind load.A silicone layer applied to

the whole contact surface protects the car roof and ensures maximum

friction.

The MZG is provided with a M8 x 1 thread mount system fitting the Procom

“ZG”-type antenna whips.
INSTALLATION

The magnetic mount should be mounted in the middle of the vehicle roof or

rear locker to produce best omnidirectionalcoverage.

TUNING

Below

400 MHz

Use the cutting diagram for the corresponding ZG-mount model

using the same type of whip as a guidewhile using an SWR-meter

to tune the whip.

Above

400 MHz

Whips tuned by cutting: Use an SWR-meter.

Whips tuned with disc: Adjustment diagram accompanies the

antenna.

PROCOM A/S reserve the right to amend specifications

without prior notice.
13/12/11