Aqua-Pure CBF150 - Manual (Page 11)

2-5
HOW TO SET TIME OF DAY
Step 1) Press SET
Step 2) Use
▲ and ▼ to adjust the current time hour. Time display will be 12 hour with PM indicator with 60 Hz line fre-
quency detection on power-up. Time display will be 24 hour without the PM indicator with 50 Hz line frequency on
power-up. Press SET and proceed to step 3.
Step 3) Use ▲ and ▼ to adjust the current time minutes. Press SET to exit Set Time of Day.
Power Loss
If power is lost for more than 8 hours, the current time of day will need to be reset. If the system is in the middle of regeneration
upon power loss, the control will continue regeneration at the point of interruption when power is restored.
Error Message
Contact the OEM for assistance if the display shows “E1,” “E2,” “E3” or “E4.” These messages are indications the valve did not
function properly.
HOW TO MANUALLY INITIATE IMMEDIATE REGENERATION
If a system needs to be regenerated before the next scheduled time, manual regeneration can be initiated. This may be neces-
sary during times of heavy water usage, including house guests or heavy laundry days.
To initiate an immediate manual regeneration, press
▲ and ▼ simultaneously for three seconds. This request cannot be can-
celled.
HOW TO MANUALLY INITIATE DELAYED REGENERATION
To initiate a manual regeneration at the preset delay time, press ▲ and ▼ simultaneously. Release. An arrow will point to REGEN
if regeneration is expected “tonight.” To cancel, press ▲ and ▼ simultaneously. Release.
STEP 1
SET
STEP 2
SET
Regen
Min. Fill
Regen
Time Time
PM
Days To
Regen
STEP 3
SET
Regen
Min. Fill
Regen
Time Time
PM
Days To
Regen
SET
Regen
Min. Fill
Regen
Time Time
PM
Days To
Regen
Arrow will point to Regen if a
regeneration is expected “Tonight.”
SET
Regen
Min. Fill
Regen
Time Time
PM
Days To
Regen