Aqua-Pure SS20 EPE-316L - Manual (Page 4)

D E
G C A B
HEIGHT REQUIRED TO
CHANGE CARTRIDGES
Elevation View
(See Plan View for True Orientation)
2
3
4
5
6
7
8
HAND KNOB
COVER
PRESSURE PLATE ASSEMBLY
COVER GASKET
V-BAND CLAMP
CARTRIDGE POSTS
DRAIN PLUG 3/4" NPT
(SLUDGE DRAIN)
CARTRIDGE
PEDESTALS
FLOW
BAFFLE
CENTER
ROD
1/4" NPT
VENT PLUG
DIRTY DRAIN
ABOVE CLEAN DRAIN
3/4" NPT
1
Plan View
T E L T U O T E L N I
8
9 T-BOLT
KIT
F
SS4-316L, SS8-316L, SS12-316L and SS20-316L Filter Housing Series
Installation
1)Installing the Filter Housing (SS4-316L, SS8-316L, SS12-316L and SS20-316L Filter Housing Series)
The fi lter housing should be placed on 8” (20 cm) cinder or cement blocks to permit ease of draining. Locate the inlet (marked as “IN” and
Outlet (marked as “OUT”) connections on the housing cylinder. Connect the water supply line piping to the Inlet connection and the fi ltered
water piping serving the building to the Outlet connection. Shut off valves are to be installed on each side of the housing (See note). DO
NOT install the fi lter housing backwards by connecting the water supply line piping to the Outlet. The drain plugs should then be removed
and either a drain line assembly (with two valves) or two hose bibs (faucets) should be installed. See Figure 1 for proper installation. Install
fi lter cartridges per Step 2 prior to fi lter housing start-up.
Note: When the housing is installed in close proximity to the water metere or pressure tank, the main shut off valve may be used for the
Inlet water control valve.
Note: Installation must comply with state and local plumbing codes.
4