Specifi cations – Aqua-Pure SS20 EPE-316L User Manual
Page 2
Congratulations on your purchase of this Aqua-Pure® high fl ow, single housing fi ltration system. This system is ideal for large homes,
restaurants, schools, clubs, farms, camps, and institutions of all types. This system is ideal for locations where fl ow rates range up to 288
gallons per minute (1,090 lpm).
The all-metal housing is available with AP110, AP117, AP017 or without cartridges and features a single clamp for easy cover removal. An
internal center rod with a tightening knob provides quick cartridge changes. All housing internal and external parts are stainless steel with
the exception of the gasket which is Nitrile rubber and the Tightening Knob which is Polypropylene.
Design Features:
• Durable corrosion resistant 316L stainless steel construction
• Shouldered seal plates fi t solidly into the cartridge core to ensure a positive cartridge seal.
• V-band clamp for quick and easy opening and closing.
• Removable cartridge posts lift out for easy cleaning.
• Housing drains; both sludge and clean chambers have drain couplings for easy draining.
• Air vent allows venting before start-up or draining.
• High fl ow design accommodates up to 288 gpm (1,090 lpm) fl ow rate.
• High temperature capacity (up to 250°F [121°C], dependent of fi lter cartridge used).*
• Manufactured from FDA CFR-21 and/or NSF compliant materials.
*Not tested or certifi ed by NSF International
Specifi cations
Model No.
Pipe Size
Dimensions
Height Diameter
Maximum
Pressure
Replacement
CTG No.
Replacement
CTG Qty
Maximum Flow Rate
AP110*
AP111
AP124
AP117
APS117
AP420*
Flow rate is based on a maximum velocity of 8 ft/sec as required by National Standard Plumbing Code for water piping systems. At velocity
of 10 ft/sec these values can be increased by 25%.
Filter life will be greater with the 25 and 50 micron cartridges.
Note: Filter housing with more cartridges at a given fl ow rate can greatly extend cartridge life.
Note: Aqua-Pure fi lter housings may be used with various fi lter cartridges.
IMPORTANT: Activated carbon fi lters should not be used on water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
SS4 EPE-316L 1
1
/
2
” NPT
19
1
/
2
”
8”
4
32 gpm
32gpm
32 gpm
12 gpm
12 gpm
32 gpm
Series
Male
(49.5 cm) (20.3 cm)
(121.1 lpm) (121.1 lpm) (121.1 lpm) (45.4 lpm) (45.4 lpm) (121.1 lpm)
SS8 EPE-316L
2” NPT
29
1
/
2
”
8”
8
64 gpm
64 gpm
64 gpm
24 gpm
24 gpm
64 gpm
Series
Male
(74.9 cm) (20.3 cm)
(242.3 lpm) (242.3 lpm) (242.3 lpm) (90.8 lpm) (90.8 lpm) (242.3 lpm)
SS12 EPE-316L
2” NPT
39
1
/
2
”
8”
12
96 gpm
96 gpm
96 gpm
36 gpm
36 gpm
96 gpm
Series
Male
(100.3 cm) (20.3 cm)
(363.4 lpm) (363.4 lpm) (363.4 lpm) (136.3 lpm) (136.3 lpm) (363.4 lpm)
SS20 EPE-316L
2” NPT
49
1
/
2
”
8”
20
160 gpm
160 gpm
160 gpm
Series
Male
(125.7 cm) (20.3 cm)
(605.7 lpm) (605.7 lpm) (605.7 lpm)
SS24 EPE-316L 3” - 150 #
40
9
/
16
”
12”
24
192 gpm
192 gpm
192 gpm
Series
Flange
(103.0 cm) (30.5 cm)
(726.8 lpm) (726.8 lpm) (726.8 lpm)
SS36 EPE-316L 3” - 150 #
50
7
/
16
”
12”
36
288 gpm
288 gpm
288 gpm
Series
Flange
(128.1 cm) (30.5 cm)
(1,090 lpm) (1,090 lpm) (1,090 lpm)
AP110
AP111
AP124
AP117
APS117
AP420
—
—
—
—
—
—
—
—
—
150 psi
(1,034 kPa)
CAUTION: To reduce the risks associated with water leakage, which, if not avoided, may result in property damage — check with your
plumbing professional to verify that water pressure is less than 150 psi.
AP017
AP110
AP111
AP124
2