English – Pfister GT49-YP1K User Manual

Page 4

ENGLISH

ENGLISH

DRAIN BODY INSTALLATION

FAUCET FUNCTIONS

MAINTENANCE & CARE

CAUTION: Maintenance

DISASSEMBLY
1.

Replacement parts may be available at the store where you purchased
your faucet.

2. When

replacement parts are not available, please write or call Price Pﬁster

Consumer Service.

Always turn off water and relieve pressure before working on your
faucet.

NOTE: Trim Care

Cleaning Instructions:
For all Handles and decorative ﬁnishes, use only a soft damp cloth to clean and
shine. Use of polish, detergents, abrasive cleaners, organic solvents or acid
may cause damage. Use of other than a soft damp cloth will nullify our
warranty!
Special Trim:
Trim products which contain Porcelain or other similar substance are not acceptable
for public areas or Commercial use. Installation of Said Trim is at Users Risk!

1–800–PFAUCET (1–800–732–8238)

For Toll-Free Pfaucet information call 1–800–PFAUCET
(1–800–732–8238) or visit www.pricepﬁster.com
• Installation Support
• Care and Warranty Information

11 WATER SUPPLY CONNECTIONS

First, thread Inlet Connectors (11A) into Water Supply Lines (11B). Then, insert Inlet
Connectors (11A) into Valve Bodies (11C).

Hot water supply lines go into left inlet.

Cold water supply lines go into right inlet. (Supply lines not included). Please follow
manufacturer’s instructions when installing supply lines. Next, insert Clips (11D) into
Valve Body Holes (11E), to secure unit.

WARNING: Do not twist Inlet Connectors (11A) once installed!

12 POP-UP INSTALLATION

Install and adjust Pop-Up (12A) using separate instructions supplied with the Pop-Up
assembly.

13 UNIT START UP

Turn on hot and cold water supplies, and check for leaks above and below the sink.

14 FAUCET FUNCTION

COLD valve: close-counterclockwise, open-clockwise; HOT valve: close-clockwise,
open-counterclockwise.

15 VALVE CARTRIDGE REMOVAL

Turn off water supplies and relieve pressure before working on your faucet
(see step 2). Remove Handles (see step 7), unscrew Retainer Nut (15A) by turning it
counter-clockwise and lift out Cartridge Assembly (15B) and inspect. Replace parts
as necessary.

HOT

OPEN

COLD

15A

15B

12A

11A

11D

11E

11D

11A

11B

11C