En g l is h, Faucet installation – Pfister GT42-SR0K User Manual

Page 2

ENGLISH

Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to

provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow

illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).

1 BEFORE PROCEEDING

WARNING: Read all the instructions completely before proceeding. Price Pfister

recommends calling a professional if you are uncertain about installing this product!

This product should be installed in accordance with all local and state plumbing and

building codes.

2 SHUT OFF WATER SUPPLY

Locate water supply inlets and shut off the water supply valves. These are usually found

under the sink or near the water meter. If you are replacing an existing faucet, remove

the old faucet from the sink and clean the sink surface thoroughly.

3 TOOLS RECOMMENDED

• Plumber’s putty

• Slotted screwdriver • Phillips head screwdriver

• Pliers

• Adjustable wrench

• Flashlight

• Cloth

Your installation may require new supply lines and / or shut-off valves or other

additional tools.

4 CHECKING THE CONTENTS OF THE BOX

Upon opening the box, check to ensure that all of the following items are included.

A Faucet

B Lift Rod

C Pop-Up Assembly

D Channel (2x)

E Sleeve (2x)

F Nut (2x)

If any of these items are missing, please contact Price Pfister Consumer Service at

1-800-Pfaucet (1-800-732-8238).

FAUCET INSTALLATION

5 FAUCET INSTALLATION

Place a bead of plumber’s putty in the groove along the bottom outer edge of Bottom

Plate (5A). From above sink, insert Threaded Shanks (5B) and Faucet Inlets (5C)

through End Holes (5D) of sink.

6 SECURING FAUCET

From underneath sink, secure the faucet by placing the Channel Washers (6A) and Nuts

(6B) onto Mounting Posts (6C). Tighten Nuts (6B) until the faucet is firmly connected

to the sink. For thin deck installations, use the support Sleeves (6D) in addition to the

Channel Washers.

Caution: Do not over tighten!

BOTTOM GROOVE