English – Pfister GT49-DC00 User Manual

Page 3

ENGLISH

ENGLISH

7 HANDLE FLANGE ATTACHMENT

Place Plastic Ring (7A) and Flange (7B) over Valve Body (7C) covering the Valve Body
Washers (7D). Secure by threading Plastic Nut (7E) onto the Valve Body (7C).

8 HANDLE INSTALLATION

Screw Stem Extender (8A) onto the Valve Stem (8B). With Valves in “Closed” position,
attach Handle (8C) onto Valve Stems (8B) and tighten Set Screws (8D) with the Hex
Wrench (8E) that is provided.

Make sure Set Screw (8D) is securely tightened to Handle (8C).

9 SPOUT BODY ATTACHMENT

Insert Lift Rod (9A) into hole at the back of Spout (9B). Place Plastic Seal Ring (9C)
against the bottom of Spout Base (9D). With Spout (9E) facing forward, carefully install
the Lift Rod (9A) and Shank (9F) through the center hole of sink (9G).

10 SECURING SPOUT BODY

From underneath sink, secure Spout Body (10A) by placing Metal Washer (10B) and
threading Long Nut (

Hex.) (10C) onto Mounting Post (10D). Make sure that the

bumps on Metal Washer (10B) are facing up. Make sure Lift Rod (10E) moves freely.
Firmly hand tighten Long Nut (10C). Secure Long Nut (10C) not to exceed a

turn.

Caution: Do not over tighten!

10A

10B

10E

10C

10D