Pfister F-034-4ALS - Manual (Page 5)

ENGLISH
ENGLISH
MAINTENANCE & CARE
17
18
19
20
CAUTION: Maintenance
DISASSEMBLY
1. Replacement parts may be available at the store where you purchased your
faucet.
2. When replacement parts are not available, please write or call Price Pfister
Consumer Service.
3. Always turn off water and relieve pressure before working on your faucet.
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative finishes, use only a soft damp cloth to clean and shine.
Use of polish, detergents, abrasive cleaners, organic solvents or acid may cause
damage. Use of other than a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar substance are not acceptable for
public areas or Commercial use. Installation of Said Trim is at Users Risk!
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.pricepfister.com
• Installation Support
• Care and Warranty Information
17 HANDLE REMOVAL
Turn off water before proceeding! With valves in closed position, detach Decorative Button
(17A), unscrew Fastener (17B), and remove Handle Hub (17C) from Valve Stem (17D).
18 CARTRIDGE REMOVAL
Turn off water supplies and relieve pressure before working on your faucet (see step
2). Remove Handle (See step 17) Remove the Dome Cap (18A) by unscrewing it in a
counterclockwise direction. Using an adjustable wrench, unscrew the Retainer Ring
(18B). Carefully remove the Cartridge (18C) by pulling it straight up and out. Inspect
Cartridge (18C) for debris or damage. Clean or replace the Cartridge (18C). Reassemble
faucet by reversing steps.
19 DECK PLATE REMOVAL
To remove Deck Plate (19A) and Putty Plate (19B) detach the Long Nut (19C) ( 7 /
16
Hex.),
Metal Washer (19D) and Nut (19E) from the Mounting Post (19F).
20 DIVERTER REMOVAL
If the side spray fails to work properly the diverter mechanism may be clogged with debris
or may need replacing. To check and/or replace Diverter (20A), shut off water supply
and relieve pressure before working on your faucet (see step 2). Remove handle (see
step 17) and Dome Cap (20B) and carefully lift up the Spout Assembly (20C). The Diverter
Mechanism (20A) is located on the backside of Inner Faucet Body (20D) Carefully remove
the Diverter Mechanism (20A) and check for debris. Clean or replace the Diverter Mechanism
(20A). Reassemble faucet by reversing steps.
5
17A
17C
17B
17D
18A
18B
18C
20B
20C
20A
20D
19A
19B
19F
19E
19D
19C