Anchor Audio Liberty Platinum - Manual (Page 8)

MADE IN USA
SIX YEAR WARRANTY
Liberty Platinum Sound System Owners Manual
For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com
ANChOr AUDIO CUSTOMEr SErvICE
800.262.4671
FOr ADDITIONAL INFOrMATION
visit www.anchoraudio.com
8
LIBERTY PLATINUM TECHNICAL SPECIFICATIONS
Rated Power Output 125 watts AC / 100 watts DC
Max SPL @ Rated Power 117 dB
Battery
Two 12 Volt rechargeable,
9.0 AH
Full recharge: approx 7 hrs.
Frequency Response 60 Hz – 15 kHz ± 3dB
Line Output (post fader) isolated, 600 W, 1/4” phone
AC Power Reqs. 100 – 240 VAC, 50/60 Hz,
300W max
DC Out
12V 500mA
USB 5V 500mA
Dimensions (HWD) 22” x 14” x 11.5”
(56 x 35.6 x 29.2 cm)
Weight (AC/DC) 38 lbs/ 17 Kg
Weight (AC only) 26 lbs/ 12 Kg
Mic Inputs: Lo-Z (1 KW), balanced, XLR
12 VDC condenser mic
(phantom) power
Hi-Z (10 KW), unbalanced,
1/4” phone
Hi-Z (10 KW), unbalanced,
1/8” stereo,1/4” phone
Line In/Out unbalanced, stereo RCA
Sensitivity For Rated Output
Lo-Z Microphone
-52 dBV (2.5 mVrms)
Hi-Z Microphone -43 dBV (7.5 mVrms)
Auxiliary (line) -14 dBV (200 mVrms)
Phantom Power 36V
(Specifications Subject to Change Without Notice)
HAVING TROUBLE WITH YOUR SOUND SYSTEM?
CONDITION POSSIBLE SOLUTION
No Sound (power LED off) • turn POWER switch ON
• charge battery or plug in AC cord
• safely shut down if unit overheats, turn volume lower &
turn speaker ON
No Sound (power LED on) • check for output from source
• make sure all cables are completely plugged in
• turn up volume control of input used
• remove plug from speaker output if not using external
speaker output
Shortened Battery Life • charge battery fully; if battery life continues to deteriorate,
contact Anchor Audio customer service: 800.262.4671
HAVING TROUBLE WITH YOUR WIRELESS SYSTEM? (Wireless Models Only)
CONDITION POSSIBLE SOLUTION
No Sound (RX Indicator: ON) • turn up WIRELESS volume control
• make sure mic is plugged into body pack transmitter
No Sound (RX Indicator: OFF) • push mic power button
• turn Liberty POWER switch on
• make sure transmitter power switch is on
• set receiver and transmitter to same channel
• replace battery in transmitter
Excessive Hum or Noise • use shielded cables
• use balanced microphone
Distorted Sound • lower system volume control
• lower input volume control