Crown Audio IQ-PIP-USP2 Adapter - Manual (Page 8)

IQ-PIP-USP2 Adapter
Installation Manual
133394-2 Rev. B
© 2002 Crown Audio, Inc.
3.4 Install the IQ-PIP USP2 Adapter
Refer to Figure 3.4 for locations of the parts described
in this procedure.
1. Mount the IQ-PIP USP2 Adapter card. Using the
mounting assembly hardware provided, mount
and secure the IQ-PIP USP2 Adapter to the rear
wall of the PIP cage. Refer to Figure 3.4 for proper
assembly order of the mounting hardware. Note:
When installing the mounting nuts, we suggest
using thread-locking adhesive on the back of
each nut.
2. Connect cables. Connect the16-pin PIP1 ribbon
cable and 5-pin signal cable from the amplifi er
to the proper connectors on the IQ-PIP-USP2
Adapter.
3. Install wire ties (optional). Using the wire
ties provided, secure the IQ-PIP-USP2 Adapter
module and cables to the PIP cage.
3.5 Install the IQ-PIP USP2 Module
1. Locate the two connectors on the underside of
the PIP circuit board (fi gure 3.5), then connect the
two input ribbon cables coming from the IQ-PIP-
USP2 Adapter. Both ribbon cables should run
smoothly from the amplifi er to the PIP module.
Figure 3.4 IQ-PIP-USP2 Adapter Installation
Figure 3.5 Ribbon Connectors on IQ-PIP-USP2
Figure 3.6 Installing the IQ-PIP-USP2
into the Amplifi er
2. Insert the PIP and attached cables into the PIP
opening in the back of the amplifi er, then screw
securely into place (see Figure 3.6).
Figure 3.3 PIP Edge Connector Dissassembly
8