Factory Direct Hardware Hansgrohe 39135 - Manual (Page 4)

4
Sit the spout on the countertop. Install the
mounting piece mounting collar.
Attach the compression Y to the bottom of the
spout fitting with the enclosed 10 mm compres-
sion fitting. The metal side of the ferrule should
point upwards. Tighten wrench tight.
Screw the connection hoses to the Y.
Attach the hoses to the valves with the enclosed
3/8“ compression fittings. Use two wrenches,
as shown, to prevent the hoses from twisting.
Connect the valves to the stops with 1/2“ supp-
ly lines (not included).
Install the drain.
Turn on the water and check all connections for
leaks.
3/4”
7/16”