Factory Direct Hardware Hansgrohe 31063 - Manual (Page 10)

10
English
Screw the connecting hoses into the spout tee.
Connect the hoses to the valve outlets.
Use two wrenches so that
the hoses do not twist or
become loosened from
the spout tee.
Install the supply lines (not included).
Install the drain.
Turn on the water and check all connections
for leaks.
Rotate the spout escutcheon if necessary, so
that the hole for the pull rod is at the rear.
Place the spout on the mounting surface.
Install the fiber washer, metal washer, and
mounting nut.
Tighten the mounting nut.
Tighten the tensioning screws.