beautypg.com

Factory Direct Hardware Hansgrohe 10074001 User Manual

Page 3

background image

3

Prepare to install the faucet:

This faucet requires 2 1/2” female threaded fittings, spaced 3 1/8” apart (on center) for the hot and

cold supplies. For proper operation of the faucet, the hot supply should be to the left, the cold to the

right. The fittings should be recessed 3/8” behind the surface of the finished wall.

Finish and seal the wall before installing the faucet.

Your local plumbing codes may require supply stops for the hot and cold water supplies. These should

be installed in an easily accessible location.

Know and follow all applicable plumbing codes regarding the air gap between the end of the spout

and the flood level of the sink.

No drain is included with this faucet. Contact the manuacturer of your specific lavatory for recommen-

dations regarding a suitable drain.

Install the faucet:

Seal the wall with a compatible, waterproof bathroom

sealant.

Wrap the threads on the offset adapters with Teflon

TM

tape. Install them to the hot and cold supplies.