Factory Direct Hardware Hansgrohe 10050 - Manual (Page 2)

08/2004
HANSGROHE PRODUCT SERVICE
1 Handle for cold / hot water 96318XXX
2 Color-ring cold / hot water 96319000
3 Handle fixing set 94184000
4 Stop unit
10030XX1/10050XX1/
10058XX1 94009000
Stop unit
10230XX1 94149000
5 Aerator 94005XXX
6 Lift rod 94083XXX
7 Tube for lav/bidet mixer 30622210
Tube for Highriser 30630910
8 Fixation set 13961000
XXX = Color code: 000
chrome
810 satinox
Spare parts
8
6
7
4
3
2
1
10030XX1/
10050XX1/
10058XX1
10230XX1
5
5
Cleaning Recommendation for Hansgrohe Products
Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to design and
functionality.
To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not covered under the
Hansgrohe warranty.
Cleaning Materials for Faucets and Showers
• To remove lime scale, use only products made specifically for that purpose. Always follow the manufacturer’s instructions when using.
• Do not use cleaners that contain hydrochloric, formic, acetic, or phosphoric acids, as these will cause considerable damage to finishes and
to plastic components.
• Never mix cleaning materials.
• Never use cleaners containing abrasives. Do not use abrasive cleaning cloths, pads, or sponges.
Cleaning Procedures
• Clean your faucets and shower products as and when required. Regular cleaning will prevent scale buildup and water spotting.
• Follow the label instructions. Do not allow any cleaner to remain on the product for longer than necessary.
• When using spray cleaners, spray first onto a sponge or cloth – do not spray directly onto the product.
• After cleaning, rinse thoroughly with clear water to remove any cleaner residue.
Important
• Soap and shampoo residue can also cause damage to the product. Rinse well with clean water after use.
• If the surface is already damaged, harsh cleaning materials will cause further damage.