Dexter Laundry T-400 (On-Premise) - Manual (Page 9)

PROGRAMMING INSTRUCTIONS:
Programming can be accomplished manually using the machine controls or by connecting to the
machine control using a PDA (personal digital assistant). For instructions on using a PDA with
this washer control, please contact your local Dexter distributor. Please read below for manual
programming instructions.
The keypad layout for the washer control is shown above.
WASH CYCLE PROGRAMMING
1.
Turn on the power to the washer.
2.
Turn the Run/Program key to the Program position. Display will show “C O” and the “ADD
BLEACH” light will blink and will continue to blink during the programming mode.
3.
Press the “DOWN” or “UP” buttons to select which cycle to alter. When the desired cycle
number is displayed, press “START”.
4.
The display should now show a “b”. The “b” and the cycle indicator lights indicate which
bath is being selected to alter. Press the “UP” and “DOWN” buttons to select a bath to
change and then press “START”. The indicator lights are shown below.
FINAL
RINSE
PRE
WASH
FLUSH WASH RINSE SPIN
When “RINSE” is selected, “b r1” through “b r4” may be selected. There may be multiple
rinses that are indicated by r1, r2, r3 and r4.
5. Each bath can be programmed with the following options. Use the “DOWN” and “UP” keys
to select the desired setting and the “START” key to move to the next option.