3B Scientific Halogen Lamp 500 W(115 V, 50__60 Hz) - Manual (Page 4)

Elwe Didactic GmbH • Steinfelsstr. 6 • 08248 Klingenthal • Germany • www.elwedidactic.com
3B Scientific GmbH • Rudorffweg 8 • 21031 Hamburg • Germany • www.3bscientific.com
Subject to technical amendments.
© Copyright 2008 3B Scientific GmbH
3. Technical data
Power: max. 500 W
Dimensions: 180 x 140 x 130 mm ³
Stand: 250 mm
Holding bracket: 140 x 110 mm²
4. Initial commissioning
Fitting the tube
• Remove the screw from the protective glass
cover. Open the glass cover.
• Use a clean, dry cloth to fix the new tube into
the spring loaded connection of the tube
holder.
• Carefully place the unconnected end of the
tube into the opposite holder.
• Make sure that the tube is fitted properly!
• Replace the protective glass cover and secure it
with the screw.
• Make sure that the sealings fit properly.
5. Operation
• Use the stand or the holding bracket to mount
or set up the halogen lamp.
• Connect the lamp to the mains.
• Pull out the plug to switch off the lamp.
6. Replacing the tube
Replacement tube U8476714
• Pull out the mains plug.
• Allow the halogen lamp to cool.
• Remove the screw from the protective glass
cover. Open the glass cover.
• To remove the tube, use a cloth or similar
material. Do not touch the tube with the bare
hand.
• Remove the old tube and replace it with a new
one.
Caution:
• Tubes are not to be disposed of together with
domestic waste.
• Adhere to the waste disposal regulations for
respective countries.