3B Scientific Halogen Lamp 500 W(115 V, 50__60 Hz) - Manual (Page 3)

3B SCIENTIFIC® PHYSICS
1
Halogen lamp U8476713
Instruction sheet
02/08 SP/ALF
1 Mains lead
2 Holding
bracket
3 Tube
4 Locking screw
5 Stand
1. Safety instructions
Safe operation of the equipment is guaranteed,
provided it is used correctly. However, there is no
guarantee of safety if the equipment is used in an
improper or careless manner. If it is deemed that
the equipment can no longer be operated without
risk (e.g. visible damage has occurred), the equip-
ment should be switched off immediately and
secured against any unintended use.
• Before putting the equipment into operation,
confirm that the specifications printed on the
rear side of the housing are compatible with
the local mains voltage.
• Before putting the equipmentinto operation,
check the housing and the mains lead for any
damage. In the event of any malfunc-
tion/operational defect or visible damage,
switch off the equipment immediately and se-
cure it from unintentional use.
• The instrument may only be connected to the
mains via a socket that has an earth connec-
tion.
Danger of burns! When used for a longer period,
the halogen lamp becomes extremely hot.
• If used for a long period, allow the lamp to
cool for at least 20 minutes.
The light produced by the halogen lamp is ex-
tremely bright.
• Do not look directly into the lamp.
2. Description
The halogen lamp can be used as a strong source of
light in experiments using the basic solar set
(U8461200).
The halogen lamp U8476713-115 is for operation
with a mains voltage of 115 V (±10%), and the unit
U8476713-230 is for operation with a mains voltage
of 230 V (±10%).