beautypg.com

AEG A60120GS4 User Manual

Page 26

background image

Problem

Possible cause

Solution

The appliance is noisy

The appliance is not supported

properly

Check if the appliance stands sta-

ble (all the four feet should be

on the floor)

The compressor operates

continually

The thermostatic control is set

incorrectly

Set a warmer temperature

Doors are not shut properly or

do not close tightly

Check if the doors close well and

the gaskets are undamaged and

clean

The door has been opened too

frequently

Do not leave the door open lon-

ger than necessary

Large quantities of food to be

frozen were put in at the same

time

Wait some hours and then check

the temperature again

Food placed in the appliance

was too warm

Allow food to cool to room tem-

perature before storing

The room temperature is too

high.

Decrease the room temperature

There is too much frost

and ice

Products are not wrapped prop-

erly

Wrap the products better

Doors are not shut properly or

do not close tightly

Check if the doors close well and

the gaskets are undamaged and

clean

The Temperature regulator may

be set incorrectly

Set a warmer temperature

It is too warm in the

freezer

Temperature regulator may be

set incorrectly

Set a lower temperature

The door does not close tightly

or it is not shut properly

Check if the door closes well and

the gasket is undamaged and

clean

Large quantities of food to be

frozen were put in at the same

time

Insert smaller quantities of food

to be frozen at any one time.

Food placed in the appliance

was too warm

Allow food to cool to room tem-

perature before storing.

Products to be frozen are

placed too closely to each other

Place the products in a way so

that cold air could circulate

among them

It is too cold inside the

freezer

Temperature regulator may be

set incorrectly

Set a warmer temperature

The appliance does not

work at all. Neither cool-

ing nor lighting works

Plug is not connected to the

mains socket properly

Connect the mains plug properly

26

What to do if…