Airbagit Spindles, Coilsprings, Shock Relocator Kit, And Control Air Arm User Manual
Page 4
You will need to hold the Eliminator barrel up to the frame and trace where you intend to
cut. Do not worry about strength because when you weld the 3/16” Thick Gauge Barrel
in place, your frame will be several times stronger than factory. The easy way to do this
is with a Plasma Cutter. A die grinder will do the job if you are patient.
Then slide the Barrel up into the cavity and “Tack-Weld” in place when you have
determined the best possible placement. SpringPocket Eliminators will allow you to use
a #3800 8.50” wide bag on a fullsize truck and allow you to lift it with under 120psi, but
the best part is the smooth ride. With twice the air volume, it takes less to lift and it has
room to breathe. A little more work, but do it right the first time.