Airbagit Block User Manual
Typical aluminum blocks, Installation instructions, Click on picture of part to purchase.)
ITEM
DESCRIPTION
MATERIAL/SPEC
1
REAR AXLE
STEEL
2
FACTORY LEAF SPRINGS
STEEL
3
EXTRUDED LOWERING BLOCKS
ALUMINUM
4
U-BOLTS
STEEL
5
1/2 -13 HEX NUTS
6
1/2 LOCK WASHERSTHINGS TO CONSIDER
Typical Aluminum Blocks
Installation Instructions
(Click on picture of part to purchase.)
DIAGRAM #15
BLOCKS.PDF
INSTALLATION INSTRUCTIONS
1. LOWERING BLOCKS ARE NOT TO BE USED IN CONJUNCTION WITH ANY OTHER LOWERING METHODS.
2. DO NOT STACK LOWERING BLOCKS.
3. MAKE SURE THAT ALL PART ARE FREE FROM CONTACT
WITH LOWERING BLOCK. (BRAKE LINES, BRAKE CABLES, SHOCK ABSORBERS, AND ANY OTHER PART THAT MAY INTERFERE).
4. BE SURE TO RE CHECK TORQUE ON THE NUTS EVERY 30 DAY.
5. MUST BE INSTALLED BY A QUALIFIED TECH.
1. LOWERING BLOCKS ARE NOT TO BE USED IN CONJUNCTION WITH ANY OTHER LOWERING METHODS.
2. DO NOT STACK LOWERING BLOCKS.
3. MAKE SURE THAT ALL PART ARE FREE FROM CONTACT
WITH LOWERING BLOCK. (BRAKE LINES, BRAKE CABLES, SHOCK ABSORBERS, AND ANY OTHER PART THAT MAY INTERFERE).
4. BE SURE TO RE CHECK TORQUE ON THE NUTS EVERY 30 DAY.
5. MUST BE INSTALLED BY A QUALIFIED TECH.INSTALLATION INSTRUCTIONS
1. READ AND UNDERSTAND ALL INSTRUCTIONS. MUST BE INSTALLED BY A QUALIFIED TECH.
2. LIFT VEHICLE AND SET FRAME ON JACK STANDS. REMOVE WHEELS FOR WORKING CLEARANCE.
3. SUPPORT REAR AXLE WITH FLOOR JACK.
4. NOW YOU MAY REMOVE YOUR FACTORY U BOLTS AND WITH YOUR JACK LIFT REAR AXLE ENOUGH TO INSERT YOUR LOWERING BLOCKS.
5. CHECK AND BE SURE THAT LOWERING BLOCKS ARE PROPERLY ALIGNED WITH VEHICLE. TIGHTEN AND TORQUE ALL NUTS TO 75 FT. LBS.
6. DRIVE TWO MILES AND RE TORQUE ALL NUTS. NUTS MUST BE RE CHECKED EVERY 30 DAYS.
7. CHECK AND MAKE SURE THAT PINION ANGLE IS CORRECT.
THINGS TO CONSIDER
1. LOWERING BLOCKS ARE NOT TO BE USED IN CONJUNCTION WITH ANY OTHER LOWERING METHODS.
2. DO NOT STACK LOWERING BLOCKS.
3. MAKE SURE THAT ALL PART ARE FREE FROM CONTACT
WITH LOWERING BLOCK. (BRAKE LINES, BRAKE CABLES, SHOCK ABSORBERS, AND ANY OTHER PART THAT MAY INTERFERE).
4. BE SURE TO RE CHECK TORQUE ON THE NUTS EVERY 30 DAY.
5. MUST BE INSTALLED BY A QUALIFIED TECH.