Airbagit Air Kit - Manual (Page 3)

On many of our struts, you might find an extra set of mounting holes
on the bottom Clevis. For the lowest position, select the top holes.
After securing in place, install the supplied Schrader Manual fill
valve, and air up to approximately 85lbs, with the wheel on, and on
the ground. making sure that your strut does not contact any body
parts during the travel. It is possible on rare cases, that the inner
fender may have to be trimmed to allow full travel without contact.
Air Management
NOTE: If you are on a tight budget, you can leave the Schrader
Valves installed, and use a small pump to adjust your height. There
are many Air Management Options, but the only one you should
consider is the Plug & Play, because ALL of the wiring and plumbing
of the valves and switches is already done for you.