Prokit's Industries MT-1233С - Manual (Page 11)

DC CURRENT MEASUREMENT
1. Red lead lo "VΩmA". Black lead to "COM”(for
measurements between 200mA and 10A connect
red lead to "10A” jack with fully depressed.)
2. RANGE switch to desired DCA position.
3. Open the circuit to be measured and connected
test leads INSERIES with the load in with current
is to measure.
4. Read current value on Digital Display.
5. Additionally,"10A"function is designed for
intermittent use only. Maximum contact time of
the test leads with the circuit is 15 seconds with a
minimum intermission time of seconds between
tests.
RESISTANCE MEASUREMENT
1. Red lead to "VΩmA". Black lead to "COM".
2. RANGE switch to desired OHM position.
3. If the resistance being measured is connected to
a circuit, turn off power and discharge all
capacitors before measurement.
4. Connect test leads LO circuit being measured.
5. Read resistance value on Digital Display.
DIODE MEASUREMENT
1. Red lead to "VΩmA", Black lead to "COM".
2. RANGE switch to "
' position.
11