PowerWalker AVR 600 - Manual (Page 3)

3. Installation and Initial Startup
Inspection
Remove the unit from the shipping package and inspect it for damage that may occur during
transportation. Notify the carrier and place of purchase if any damage is found.
Placement & Storage Conditions
Install the unit in a protected area that is free of excessive dust and has adequate air flow. Please
place the AVR away from other units at least 2.5cm to avoid interference. Do NOT block the top or
side air vents on the unit.
Do not operation the unit in an environment where the ambient temperature or humidity is outside
the limits listed in the specifications. Operate the unit in an environment free of excessive dust,
mechanical vibration, inflammable gases and explosive or corrosive atmospheres.

Connect to the Wall Outlet
Plug the input power cord of the unit to the wall outlet.

Connect the Loads
Plug in the loads to output receptacles of the unit and switch the unit “ON” by pressing the
side panel ON/OFF switch to “ON” position. Then the connected devices will be powered.

Connect Modem/Phone for Surge Protection (Only for the model with RJ-11)
Connect a single modem/phone line into surge-protected “IN” outlet on the unit. Connect
from “OUT” outlet to the computer with phone line cable.

Turn On/Off the Unit
Turn on the unit by pressing the power switch to “ON” (l)position. This switch may be
used as the master ON/OFF switch for all connected devices.
EN