BabyTrend CC13700 - EZ FLEX-LOC INFANT CAR SEAT - POMEGRANATE - Manual (Page 23)

1. Locate a UAS seating position as identified in your vehicle
owner’s manual. Some UAS seating positions may require
deploying of anchors, or installation of guides.
2. Remove the Infant Seat from the base by squeezing the base
release handle located under the center of the foot end of the
Infant Seat and lifting upward on the Infant Seat. (Fig. 25-1)
3. Rotate retainer (Fig. 44-1a) and press the
red release button of the UAS connectors
and remove the connectors from their
storage position inside the base (Fig. 44-
1b) (Reverse these steps to re-store UAS
connectors). Place the Base in the rear-
facing position in a forward facing vehicle
seat as shown in Fig. 45-1. The Child
must face the rear of the vehicle and Infant
Seat must be placed in a vehicle seat that
faces forward.
4. Locate the UAS anchors in the vehicle
seat. (Fig. 44-2) Once located, snap the
Infant Seat UAS connectors onto the steel
rod. Listen for the click and check that
both connectors are firmly attached to
the anchor rods by pulling outward on the
connectors. (Fig. 45-2)
5. Proper installation of the Base requires
that the UAS webbing be very tight. To
tighten the webbing, push down hard
45 44
7.0
INSTALLATION
Fig. 44-1
Fig. 44-2
7.0
INSTALLATION
with your knee or hand on the Base while
pulling upward on each webbing end.
The webbing will automatically lock in
place. Check that there is no slack in the
webbing on both sides of the base and
that the base is tightly installed. Fig. 45-2
and 45-3.
6. Check that nothing is on top of the base or
anything that will interfere with the proper
latching of the Infant Seat to the Base. Place
the Infant Seat onto the Base and push down
until the Infant Seat latches securely to the
Base and you hear a click. Pull upward on
the Infant Seat to check that the Infant Seat is
securely latched onto the base. (Fig. 25-1)
If the Infant Seat does not securely latch
onto the Base, the Infant Seat will provide
No Protection for your child. DO NOT use
the Infant Seat with the Base if it does not
securely latch onto the Base. Please call
Baby Trend at 1-800-328-7363 for assistance.
7. To remove the base from the vehicle,
squeeze the webbing release button
on the UAS connector to loosen the
webbing. (Fig. 46-1a) Please note that
the UAS connector can not be released
from the UAS anchor if the webbing
is tight. Press the UAS hook release
Fig. 45-1
Fig. 45-2
Fig. 45-3
A
B
UAS
Snap onto anchors