BabyTrend 8025 - LAUREL OAK PLAY YARD - Manual (Page 4)

5. Place mattress in Playard with padded side up (Fig. 8).
6. Feed the 6 hook and loop straps (found underneath the mattress), 3 on
each end of the mattress pad, through the slots on the bottom of the
sides of the Playard. Fasten the hook and loop tabs to the underside
of Playard to prevent the mattress from moving (Fig. 9) (Fig. 10).
WARNING:
To prevent child from
becoming entraped under the mattress pad
and suffocating, hook and loop straps MUST
be secured to underside of Playard.
NEVER LEAVE INFANT IN PRODUCT
WITH SIDES DOWN. Infant may roll into
space between pad and loose mesh side
causing suffocation.
Assembly is now complete and playard is ready to use.
4
Figure 8.
Figure 9.
Figure 10.
FOLDING PLAYARD
1. Undo the 6 hook and loop straps holding mattress from underneath
Playard fl oor. Remove mattress and set aside.
2. Grasp the center fl oor strap and lift upward until handle is as high
as the top rails. Gather the four feet of the playard together so that
they nearly touch each other. See fi gure 1 and 2.
NOTE: TOP RAILS OF THE PLAYARD ARE STILL IN THE
“LOCKED” POSITION.
3. Locate release button on the center of the bottom of each top rail.
Lift slightly while squeezing button until the rail clicks. Push down
on rail (while still holding release button in) until side forms a “U”.
Repeat for remaining sides (Fig. 3).
NOTE: If top rail(s) do not form the “U” completely do not force.
Check the fl oor of your Playard to make sure all bottom rails are
unlocked and pull up on middle handle of fl oor again. Repeat
step 3.
Pull Up
Figure 1
Figure 2