Dual Electronics XHD6425 - Manual (Page 26)

6
Problem Cause Action
Unit will not turn on
(no power)
Yellow wire not connected or incorrect voltage
Red wire not connected or incorrect voltage Check connections for proper
voltage (11~16VDC)
Black wire not connected Check connection to ground
Fuse blown Replace fuse
Unit has power
(but no sound)
Speaker wires not connected Check connections at speakers
One or more speaker wires touching each
other or touching chassis ground Insulate all bare speaker wires from
each other and chassis ground
Unit blows fuses
Yellow or red wire touching chassis ground Check for pinched wire
Speaker wires touching chassis ground Check for pinched wire
Incorrect fuse rating Use fuse with correct rating
Excessive skipping
Unit is not mounted correctly or backstrap is
not secure Check mounting sleeve and
backstrap support
Physical defect in media (CD, CD-R or CD-RW) Check media for scratches
ERROR-01 appears
on display
Disc read error Press EJECT or RESET
ERROR-02 appears
on display
Focus error or disc is in upside down Press EJECT or RESET
PROTECT appears
on display
The WMA file is copy-protected by DRM
(Digital Rights Management) Write disc using WMA files that are
not copy-protected
NO FILE appears
on display
Selected file is not available in direct or
alphanumeric search modes Repeat search using valid
parameters
INVALID appears
on display
The file format is incompatible Write disc using valid audio files
with .mp or .wma file extensions
Unit will not accept
a disc
CD mechanism position out of alignment Press and hold EJECT for seconds
to reset CD mechanism position
CD transit screws still in place Remove transit screws located on
top of the unit
PAIRING FAILED appears
on the display
Pairing attempt has exceeded 60 seconds Retry pairing sequence. Pairing
must complete within 60 seconds
Phone is not setup correctly to connect to a
bluetooth hands free device Check the owners manual for
instructions on enabling bluetooth
Bluetooth device is not compatible with the
BTM60 Call 1-866-8-5476 for the latest
compatibility information
BTM60 reset
Reset the BTM60 to clear the memory of
previously paired mobile devices and to clear
recent dialed/missed/received phone calls
from memory From Bluetooth standby mode,
press and hold MODE for BTM60
reset.
NO SUPPORT appears on
display
An invalid ID tag version is present Version 1.x ID tags are supported.
Version .0 or greater are not
supported
Troubleshooting - General
XHD6425 OPERATION