Rainbow Electronics MAX1449 - Manual (Page 4)

Note 1: SNR, SINAD, THD, SFDR and HD3 are based on an analog input voltage of -0.5dB FS referenced to a +1.024V full-scale
input voltage range.
Note 2: Intermodulation distortion is the total power of the intermodulation products relative to the individual carrier. This number is
6dB better if referenced to the two-tone envelope.
Note 3: Digital outputs settle to V IH ,V IL .
Note 4: With REFIN driven externally, REFP, COM, and REFN are left floating while powered down.
MAX1449
10-Bit, 105Msps, Single +3.3V, Low-Power
ADC with Internal Reference
4 _______________________________________________________________________________________
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS
Input Hysteresis V HYST 0.1 V
I IH V IH = V DD = OV DD
±5 µA
Input Leakage
I IL V IL = 0 ±5
Input Capacitance C IN 5 pF
DIGITAL OUTPUTS (D9–D0)
Output Voltage Low V OL I SINK = 200 µA 0.2 V
Output Voltage High V OH I SOURCE = 200 µA
OV DD
- 0.2
V
Three-State Leakage Current I LEAK
OE = OV
DD
±10 µA
Three-State Output Capacitance C OUT
OE = OV
DD 5 pF
POWER REQUIREMENTS
Analog Supply Voltage V DD 2.7 3.3 3.6 V
Output Supply Voltage OV DD 1.7 3.3 3.6 V
Operating, f IN = 20MHz at -0.5dB FS 58 74 mA
Analog Supply Current I VDD
Shutdown, clock idle, PD = OE = OV DD 4 15 µA
Operating, C L = 15pF , f IN = 20MHz at
-0.5dB FS
10 mA
Output Supply Current I OVDD
Shutdown, clock idle, PD = OE = OV DD 1 10 µA
Offset ±0.1 mV/V
Power Supply Rejection PSRR
Gain ±0.1 %/V
TIMING CHARACTERISTICS
CLK Rise-to-Output Data Valid t DO Figure 6 (Note 3) 5 8 ns
OE Fall-to-Output Enable t
ENABLE
Figure 5 10 ns
OE Rise-to-Output Disable t DISABLE Figure 5 15 ns
CLK Pulse Width High t CH Figure 6, clock period 9.52ns
4.76
±0.47
ns
CLK Pulse Width Low t CL Figure 6, clock period 9.52ns
4.76
±0.47
ns
Wake-Up Time t WAKE (Note 4) 1.5 µs
ELECTRICAL CHARACTERISTICS (continued)
(V DD = +3.3V, OV DD = +2.0V; 0.1µF and 1.0µF capacitors from REFP, REFN, and COM to GND; V REFIN = +2.048V, REFOUT
connected to REFIN through a 10k Ω resistor, V
IN = 2Vp-p (differential with respect to COM), C L
≈ 10pF at digital outputs,
f CLK = 105MHz, T A = T MIN to T MAX , unless otherwise noted. Typical values are at T A = +25°C.)