Rainbow Electronics MAX1122 - Manual (Page 4)

MAX1122
1.8V, 10-Bit, 170Msps Analog-to-Digital Converter
with LVDS Outputs for Wideband Applications
4 _______________________________________________________________________________________
ELECTRICAL CHARACTERISTICS (continued)
(AV CC = OV CC = 1.8V, AGND = OGND = 0, f SAMPLE = 170MHz, differential sine-wave clock input drive, 0.1µF capacitor on REFIO,
internal reference, digital output pins differential R L = 100Ω ±1%, C L = 5pF, T A = T MIN to T MAX , unless otherwise noted. ≥25°C guar-
anteed by production test, <25°C guaranteed by design and characterization. Typical values are at T
A
= +25°C.)
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS
Output Offset Voltage OV OS 1.125 1.310 V
LVCMOS DIGITAL INPUTS (CLKDIV, T /B)
Digital Input Voltage Low V IL
0.2 x
AV CC
V
Digital Input Voltage High V IH
0.8 x
AV CC
V
TIMING CHARACTERISTICS
CLK to Data Propagation Delay t PDL Figure 4 1.5 ns
CLK to DCLK Propagation Delay t CPDL Figure 4 3.43 ns
Data Valid to DCLK Rising Edge
t CPDL -
t ADL
Figure 4 (Note 2) 1.67 1.93 2.35 ns
LVDS Output Rise-Time t RISE 20% to 80%, C L = 5pF 460 ps
LVDS Output Fall-Time t FALL 20% to 80%, C L = 5pF 460 ps
Output Data Pipeline Delay t LATENCY 8
Clock
cycles
POWER REQUIREMENTS
Analog Supply Voltage Range AV CC 1.7 1.8 1.9 V
Digital Supply Voltage Range OV CC 1.7 1.8 1.9 V
Analog Supply I AVCC f IN = 100MHz 210 275 mA
Digital Supply Current I OVCC f IN = 100MHz 45 75 mA
Analog Power Dissipation P DISS f IN = 100MHz 460 630 mW
Offset 1.6 mV/V Power-Supply Rejection Ratio
(Note 3)
PSRR
Gain 1.9 %FS/V
Note 1: Static linearity and offset parameters are computed from a best-fit straight line through the code transition points. The full-
scale range is defined as 1023 x slope of the line.
Note 2: Parameter guaranteed by design and characterization; T
A = T MIN to T MAX .
Note 3: PSRR is measured with both analog and digital supplies connected to the same potential.