beautypg.com

Rainbow Electronics aP89042 User Manual

Page 2

background image

Integrated Circuits Inc.

aP89042

Ver 3.0 Dec 6, 2006

2

FEATURES

l Standard CMOS process.
l Embedded 1M EPROM.
l 42 Sec Voice Length at 6 KHz sampling and 4-bit ADPCM compression.
l Maximum 32 Voice Groups
l Combination of voice building blocks to extend playback duration.
l 960 table entries are available for voice block combinations.
l User selectable PCM or ADPCM data compress.
l Two triggering modes are available by whole chip option during voice compilation.

- Key Trigger Mode – Combinations of S1 ~ S8 to trigger up to 32 voice groups; SBT

for sequential trigger of the beginning 16 voice groups..

- CPU Parallel Trigger Mode – Combinations of S1 ~S5 with SBT goes HIGH to strobe

start the voice playback.

l Voice Group Trigger Options: Edge / Level; Hold / Un-hold; Retrigger / Non-retrigger.
l Whole Chip Options: Ramp / No-ramp; Output Options; Key / CPU trigger mode.
l 16ms (@ 8KHz sampling rate) Debounce Time for both Key CPU Trigger Mode.
l RST pin set to HIHG to stop playback at once.
l Three user programmable outputs for STOP plus, BUSY signal and flashing LED.
l Built-in oscillator to control sampling frequency with an external resistor.
l 2.2V – 3.6V single power supply and < 5uA low stand-by current.
l PWM Vout1 and Vout2 drive speaker directly.
l D/A COUT to drive speaker through an external BJT.
l Development System support voice compilation and options selection.

DESCRIPTION

aP89042 high performance Voice OTP is fabricated with Standard CMOS process with embedded 1M

bits EPROM. It can store up to 42 sec voice messages with 4-bit ADPCM compression at 6KHz

sampling rate. 8-bit PCM is also available as user selectable option. Two trigger modes, simple Key

trigger mode and Parallel CPU trigger mode facilitate different user interface. User selectable

triggering and output signal options provide maximum flexibility to various applications. Built-in

resistor controlled oscillator, 8-bit current mode D/A output and PWM direct speaker driving output

minimize the number of external components. PC controlled programmer and developing software are

available.