RocketFish RF-TRSPIPAD - Quick Setup Guide - Manual

QUICK SETUP GUIDE
Bluetooth Speaker
for iPad 2
RF-TRSPIPAD
Thank you for purchasing this high quality
Rocketfish product. Your Bluetooth speaker
represents the state-of-the-art in iPad®
accessories and is designed to integrate
easily into your iPad’s Smart Cover.
Charging your speakers fully for
the first time
1 Plug the small end of the included USB
cable into the speakers and the other end
into an available USB port on your
computer.
2 If the speaker is off (the LED is off) and
you plug in the USB cable to charge the
battery, the LED blinks red and green
(indicating the speaker is in pairing
mode).
If no connection is established within
three minutes, the speaker will turn off
again and the LED will turn yellow
(charging). The LED turns off when your
speakers are fully charged.
3 When your speaker is connected, the
indicator blinks red when charging and
turns green when fully charged.
Note: You can charge your speakers and
listen to audio at the same time.
Installing the speaker unit into
the Smart Cover
Place the highlighted areas of the speaker
unit and the Smart Cover together in the
orientation illustrated in Step 1, then
proceed with the rest of the steps.
Turning on and pairing your
devices
Turn on the speakers by pushing in on the
side with the power on icon. This should
turn on the unit and automatically put it in
pairing mode. (Repeat the action on the
opposite side to pop out the other speaker
for better audio quality.)
Established
connection
(Green LED)
Charging in
Progress indicator
(Red blinking LED)
Full Charge indicator
(Constant green LED)
Note: Speakers will work with
most Bluetooth audio devices.
Speaker unit
Smart Cover
LED turns to yellow
when charging