Information submenu, Factory default settings – Cobalt Digital COMPASS 9031 HD_SD 12-bit Analog to Digital Converter User Manual
Page 14
Page 14 of 22
9031 Owner’s Manual
••••
(V 2.1)
Select Preset
Select from one of the five saved presets.
Save Settings
In this parameter, move the toggle switch up to save the settings to the card persistent storage.
Load Settings
In this parameter, move the toggle switch up to load the saved settings and make them active.
Restore Factory Settings
In this parameter, move the toggle switch up to make the factory default settings active, and make the
stored settings equal to the factory settings.
Information Submenu
Menu Structure
Parameter Type
Info
+POW
Positive Watts Consumed
-POW
Negative Watts Consumed
SWR#
Software Release Number
SWB#
Software Build Number
Positive Watts Consumed
A read only indication of power consumed by the card from the frames +12V rail.
Negative Watts Consumed
A read only indication of power consumed by the card from the frames +-7.5V rail.
Software Release Number
A read only indication of the software release number. A higher number is newer release of software.
Software Build Number
A read only indication of the software build number. Software build number is an internal indicator
used by Cobalt engineers to differentiate different software builds.
Factory Default Settings
The factory default settings are as follows
1)
The proc module is enabled, but all parameters are set to unity.