Moog Music MINITAUR - Manual (Page 18)

CV TO MIDI CONVERSION
Minitaur can now convert multiple channels of Control Voltage to MIDI! This
allows you to take CV sources such as modular synths, a CP-251 Control Proces-
sor or a Moog Etherwave Pro Theremin, and translate the voltage into MIDI
control for your plug-in effects, soft synths, or other MIDI gear.
All Minitaur sound parameters have an assigned MIDI CC number. When a
parameter value changes, Minitaur sends out MIDI CC data over its USB MIDI
connection. When one of the Controller Inputs is mapped to a non-default
parameter, Minitaur will send out CC messages for that parameter in response to
control voltage changes at the input.
In order to get optimal response from the CV to MIDI conversion, you will need
to adjust the scale and range of the control voltage to stay within the range of 0
to +5 Volts, before applying voltage to the Controller Input.
WARNING: Do not apply a negative control voltage, or a CV greater
than +5 Volts.
MINITAUR’S GLOBAL PARAMETERS AND THEIR
DEFAULT VALUES:
MIDI CLOCK LED ENABLE: OFF, ON / DEFAULT = OFF / 14 BIT
MIDI OUTPUT: OFF, ON / DEFAULT = OFF / NOTE: If on, panel knobs send 14 bit
CC data.
DECAY/RELEASE MODE: MODE 1 (Decay/Release are linked) / MODE 2
(Decay/Release independent) / DEFAULT = MODE 1
KNOB MODE: SNAP, PASS-THRU, AND RELATIVE / DEFAULT = RELATIVE
MIDI CHANNEL IN: 1 - 16 / DEFAULT = 1
MIDI CHANNEL OUT: 1 - 16 / DEFAULT = 1
KEYBOARD PRIORITY: LOW, HIGH, LAST NOTE / DEFAULT = LAST NOTE
TRIGGER MODE: SINGLE TRIGGER (legato on), MULTI-TRIGGER (legato off) /
DEFAULT = SINGLE TRIGGER
LFO SYNC PHASE RESET: OFF, ON / DEFAULT = ON
LOAD PRESET MOD WHEEL VALUE: OFF, ON / DEFAULT = OFF
!
MINITAUR REV 2 ADDENDUM