Peerless Water 30 FME-XTR Series - Service-Owners Manual - Manual (Page 10)

474 brine safety valve assembly
complete (includes all parts)
The 474 Safety Brine Valve System consists of three components
which can be ordered separately.
1. 474 Air Check Assembly
The 474 air check assembly is available in one length; riser is 1/2” in
diameter. Please specify 30.75” length when ordering. See order number
below.
2. 474 Safety Brine Valve
The 474 safety brine valve includes a 3/8” elbow with polytube insert.
3. 474 Float Assembly
There is one float length available. The 32” (overall length) float assembly is
designed to be used as the primary brine refill shut-off. It is easily adjusted
with two grommets to fit your system (not shown).
Our 474 safety brine valve system incorporates the
474 air check assembly to provide higher flow rates
and greater flexibility than traditional brine delivery
systems. Featuring a 1/2” riser pipe, our 474 safety brine valve
system is capable of providing brine draw and refill rates up
to 1-1/2 gallons per minute. The 474 safety brine valve
system is used as a the primary brine shut-off valve.
1/2” riser pipe
Higher flow rates-refill and brine draw up to 1-1/2 GPM with 3/8” elbow
Fits both 3-1/2” and 4” brine wells
Can be used as a safety back-up float or primary brine shut-off
Components are air tested to ensure proper performance
474 Float Assembly 32” w/2 Grommets
474 Brine Safety Valve w/3/8” elbow
474 Air Check 1/2”x30.75”
J7500-474 H4640-32
H4600
H4500-30.5
u sed in these models:
Softeners: 20 FM/M and 30 FM/M, 30 FME-XTR, and 30 FME-S-XTR and 30 CME
Filters: 10 NIT-W and 10 TF-W
Page 9