Dynatek Labs M6 - Manual (Page 6)

To receive a customized proposal,
contact us today at:
Dynatek Labs
105 East 4th Street
Galena, MO 65656
800.325.8252
1.417.357.6155
www.dynateklabs.com
M6 Specifications
Description Specification
Test capacity 2-6 valve samples
Valve test chamber 6; design based on customer requirements
Valve test chamber material Acrylic, for full visibility of valve status at all times
Sample type Tissue and Mechanical Heart Valves, Septal Defect Closures, Artificial
Heart Bladders, Membranes/sheets, Sutures/clips; Intra-aortic balloons,
Percutaneously-delivered Valves
Motor ¼ hp DC (½ hp DC optional)
Volume capacity 1-2 liters
Measured parameters Cycle count, frequency, pressure, temperature
Fluid temperature 25º to 40ºC
Temperature accuracy ±0.3ºC of set temperature
Speed Up to 33Hz (50Hz with the optional ½ hp motor*)
Speed control Closed loop feedback type, user adjustable
Temperature control Microprocessor based with RTD sensor
Working fluid PBS, water, blood analog
Pressure transducers Two optional; one each for inflow and outflow
Back pressure on test valve User adjustable via Throttle Valve
Pump type Pistonless Swash Plate, adjustable, with bellows
Controller Controller features digital speed count,
pressure and temperature readouts, and drive controls
Software Invitroflow software package, with intuitive user interface to monitor
and control the M6
Capacitance tank 2 liters capacity, to provide air-water interface between the Controller
and the M6
Dimensions 12” Dia. X 22.5” H
Power requirement 115 AC
Weight 72 lbs, dry
Specifications are subject to change without notice.
*Sample design, size and compliance will determine the highest frequency at which the test can be performed with high confidence.
Dynatek’s Model M6 Heart Valve Tester Specifications
Optional table for M6, with manual tilt top,
to assist in debubbling operations
M6™ and Invitroflow™ are trademarks of Dynatek Labs, Inc.