HON Enable - Manual (Page 2)

Enable™ Student Desk
Technical Specifications
2
Rev. - 1/17/2011
© 2010 The HON Company
The HON Company [email protected]
200 Oak Street 866-833-8964
Muscatine, IA 52761 www.hon.com
Accessories: 20”x 26” size desks may use the HCLA45 or
HCLA50 book box as an accessory for field installation, or
may be ordered with the HCLA45 book box installed. Other
accessories that may be used on all desks include the
HCLA65 Back Pack Hook, and the HGDK3-F Felt Glide
Cap Kit.
Compliance: The Enable Student Desks meet or exceed
applicable ANSI/BIFMA and ISTA performance standards.
Student Desks are SCS certified Indoor Advantage Gold
conforming to the ANSI/BIFMA furniture emissions
standard for open plan and conforms to the Collaborative
for High Performance Schools (CHPS) EQ 2.2 and CA
Section 01350.
Shipping: Adjustable height desks ship with the upper leg
assembly attached to the desk top. The lower adjustable
leg ships unattached for field installation.
Fixed height desks ship fully assembled.
All desks ship two (2) per carton.
Frame Assembly - Adjustable Height Models: Sturdy
four-leg assembly is comprised of an upper leg, lower leg,
and a U-brace. The upper leg is a 19.5” long, 1.13”
diameter 18-gauge steel tubing and finished with powder
coat paint. The upper legs are welded to two 15.88” x 2.5”
12-gauge steel mounting plates. Mounting plates are
attached to the work surface using five phillips drive
screws. The U-brace is 0.75” diameter powder coated
16-gauge steel tubing and is welded to the upper legs. The
lower inner leg is a 1” diameter, 14-gauge steel tube with a
chrome plated finish and is attached to the upper leg using
one ¼”-20 phillips drive screw per leg. Overall nominal
height adjustment range is 23” – 33”.
Frame Assembly – Fixed Height Models: Sturdy four-leg
frame assembly is comprised of four fixed height legs and a
U-brace. Fixed leg work surface nominal height is 30.00”
The leg is 1.13” diameter 14-gauge steel tubing and
finished with powder coat paint. The legs are welded to
two 15.88” x 2.5” 12-gauge steel mounting plates.
Mounting plates are attached to the work surface using five
phillips drive screws. U-brace is 0.75”” diameter powder
coated 16-gauge steel tubing and is welded to the legs.
Both adjustable and fixed height desk legs include 1”
diameter press-fit steel swivel glides with nylon inserts. Felt
glide caps are recommended for use on VCT flooring and
are available as an accessory for field installation.
QUICK REFERENCE TABLE
Item Inside Dimension
Load
Capacity Storage
Capacity
Use with:
HCLA45
(plastic book box)
HCLA50
(wire book box)
HCLA65
(backpack hook)
HGDK3-F
(felt glide kit)
19.5"w x 18.5"d x 5"h
N/A All Models
N/A N/A N/A All Models
19"w x 17.5"d x 4"h 30 lbs. 1,330 in³ 20x26 only
30 lbs. 1,803 in³ 20x26 only
N/A 20 lbs.