SCT-Germany 2-TAKT UNIVERSAL API TC - Manual (Page 2)

6. Accidental release measures
· Safety measurments to Protect Persons: Mark the spillage. Use personal protection as stated
in section 8.
· Safety measurments to Protect Enviroment: Contain the spillage using sand, soil or other
suitable material. Avoid seepage into the drains. Collect the spillage using cloths or an oil
absorbent material. Immediately inform the government agency (fire brigade) if the spillage
7. Handling and storage
· Handling: Storage correctly to avoid spillage and oil vapours.Ensure the area is well ventilated.
· Information on fire and explosion protection: Keep ignition sources away-Do not smoke.
· Storage: Best under cover. Store container on their side so that the filling bungs are under the
fluid level.
8. Exposure controls/personal protection
· Exposure control: Ensure a high level of personal hygiene. Ensure good ventilation.
Do not wear cloths that are contaminated with product. Do not put oil wet cloth/twist in your pocet.
If there is a risc of direct contact or splashes, wear face visor or glogges, impervious gloves and
protective clothing.
· General protective and hygienic measures: Do not inhale vapour. Avoid contact with eyes and
skin. Ensure a high level of personal hygiene. Ensure good ventilation. Do not wear cloths that
are contaminated with product. Do not put oil wet cloth/twist in your pocet.Wash hands before
breaks and at the end of work. If there is a risc of direct contact or splashes, wear face visor or
glogges, impervious gloves and protective clothing.
· Respiratory protection: not required on normal handling.
· Hand protection: Protective gloves:
Nitrile rubber gloves (minimal thickness 0.33mm), Breakthrougn time 480 min (EN 374),
Butyl rubber gloves( minimal thikness 0.8 mm), Breakthrough time 120 min ( EN 374).
In practise, due to variable exposure conditions, this information can only be an aid to orientation
for selection of a suitable chamical protection glove. In particular, this information does not
substitute suitability tests by the end user.
General information: Gloves should be replaced regularly, especially after extended contact with
the product. For each work-place asuitable glove type has to be selected.
· Eye protection: Use suitable face visor or tightly fitting goggels.
escapes into the drains of waterways. At large spillage inform the government agency (fire brigade).
Collect material to be handled as advised under section 13.
Page 2/4
Prepared according to Annex II of EC Regulation 1907/2006
MANNOL 2-TAKT UNIVERSAL
9. Physical and chemical properties
· General Information
· Form: Fluid
· Colour: Green
· Odour: Oil. Faint
· Value/Range Unit Method
· Change in condition
· Melting point/Melting range: Undetermined.
· Boiling point/Boiling range: Undetermined.
· Flash point: 100 °C
· Density at 20 °C: 0.880-0.890
Printing Date: 27.05.2010 Revision Date: 09.05.2010