SCT-Germany HYPOID GETRIEBEOEL SAE 80W-90 API GL 5 - Manual (Page 2)

MATERIAL SAFETY DATA SHEET Page 2/2
Printing Date 28.05.2004
Reviewed on 26.02.2003
7. Handling and storage
· Handling:
· Information for safe handling: No special measures required.
· Information about fire - and explosion protection: No special measures required.
· Storage:
· Requirements to be met by storerooms and receptacles: No special requirements.
· Information about storage in one common storage facility: Not required.
· Further information about storage conditions: None.
8. Exposure controls/personal protection
· Additional information about design of technical facilities: No further data; see item 7.
Ingredients with limit values that require monitoring at the workplace: Not required.
· Additional information: The lists valid during the making were used as basis.
· Personal protective equipment:
· General protective and hygienic measures:
The usual precautionary measures are to be adhered to when handling chemicals.
· Respiratory protection: Not required.
· Protection of hands: The glove material has to be impermeable and resistant to the product/the
substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the
preparation/ the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and
the degradation
· Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further
marks of quality and varies from manufacturer to manufacturer.
· Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves
and has to be observed.
· Eye protection: Goggles recommended during refilling
9. Physical and chemical properties
· General Information
· Form: Fluid
· Odour: Characteristic
· Value/Range Unit Method
· Change in condition
· Melting point/Melting range: Undetermined.
· Boiling point/Boiling range: Undetermined.
· Flash point: > 100 ° C
· Ignition temperature: > 200 ° C
· Danger of explosion: Product does not present an explosion hazard.
· Explosion limits:
· Lower: 50 g/m³
· Upper: 250 g/m³
· Density: Not determined.