Danze D562054 - Installation Manual - Manual (Page 3)

Operation Manual
2 ®
DANZE ALWAYS RECOMMENDS THAT PLUMBING PRODUCTS BE INSTALLED BY A LICENSED PROFESSIONAL.
1.
2.
NOTE : Before trim installation, make sure the
finished wall falls between the limits marked on the
plaster guard.
Remove the plaster guard from the 3/4” mixing valve.
3.
Install limit stop, making sure the gun sight and notch on
the valve cartridge stem are all aligned (see illustration).
Place the gasket and escutcheon over valve stem and attach with
handle trim ring. Secure the wall escutcheon by rotating the handle
trim ring clockwise.
Note: locate the notch in the escutcheon at the bottom.
© 2008 Danze, Inc. All rights reserved.
WARNING!
Do not rotate cartridge stem without trim in place or designated in the adjustment procedure.