Danze DC014110 - Installation Manual - Manual (Page 4)

4
InstallatIon InstructIons
1. Assemble the bidet faucet and drain (not in-
cluded) according to the manufacturer’s recom-
mendations.
2. Set bidet (A) into place on the floor.
3. Trace outline of bidet base and the mark the
location of the floor anchoring holes.
4. Set the bidet (A) aside while installing the floor
anchor bolts (J).
5. Floor expansion anchors (M) are included for
installation in concrete slab or tile surfaces. For
installations using the floor expansion anchors
(M), drill two ¼" diameter holes at the floor an-
choring hole locations. For installations using the
floor anchor bolt (J) without the floor expansion
anchor (M), drill two ¼" diameter holes at the
floor anchoring hole locations.
6. Screw the floor anchor bolts (J) into the drilled
holes.
7. Place the bidet (A) over the floor anchor bolts
(J). The floor anchor bolts (J) should extend
above the base of the bidet (A).
8. Place one floor anchor washer (K) over each
floor anchor bolt (J) and assemble the floor an-
chor nuts (L). Tighten the floor anchor nuts (L)
carefully until the floor anchor nuts (L) are just
snug. Be careful not to over tighten the floor an-
chor nuts (L).
9. Install the ceramic floor bolt cover plates (O)
by firmly pressing the ceramic floor bolt cover
plates (O) into the recesses in the side wall of
the bidet (A). (Six additional strips of hook and
loop tape (P) are provided should replacements
be needed in the future.)
10. Complete the faucet and drain connections
per the manufacturer’s recommendations.
Please refer to Homeowner Care Manual for care and maintenance information.