Danze DC013230-DC012223 - Installation Manual - Manual (Page 4)

7. Assemble toilet tank to bowl gasket (F) to
flush valve shank so that lock nut is enclosed in
recess, making sure that the entire surface of the
toilet tank to bowl gasket (F) is in contact with
the toilet tank bottom.
8. Place two channel pads (G) onto the posts on
back of toilet bowl ledge to prevent china-to-
china contact.
9. Place toilet tank assembly in position. Tighten
the plastic wing nuts (E) sufficiently by hand to
prevent rocking. Since the toilet tank mounting
bolts (C) are already sealed, the toilet tank (B)
can be leveled by the relative amount that each
plastic wing nut (E) is pulled down on the three
points of contact- toilet tank to bowl gasket (F)
and two channel pads (G).
10. The fill valve coupling nut (H) is provided to
connect the water supply line to the fill valve.
Do not use pipe dope! Hand tighten only!
Overtightening may split the fill valve and will
void the warranty.
11. If using a flexible water supply line (not in-
cluded), assemble the flexible water supply line
to the threads of the toilet tank fill valve. Do not
use Teflon tape or pipe dope on the fill valve
threads. This could result in over-tightening and
breakage.
2. Install new wax ring (not included) on the bot-
tom of the toilet bowl (A) making sure not to
cover the toilet bowl outlet. (Alternate Method:
The wax ring may also be placed onto the floor
flange.)
3. Install the new floor mounting bolts (not in-
cluded) upright in the slots of the floor flange.
Place the toilet bowl (A) over the floor flange/
waste line opening by aligning the floor mount-
ing bolts in the toilet floor bolt holes. Press
down firmly and twist toilet bowl (A) slightly to
compress wax ring and assure a seal between
the toilet bowl (A) and floor.
4. Place one plastic washer (O) over each floor
mounting bolt and assemble the floor mount-
ing bolt nut to the floor mounting bolt. Tighten
the floor mounting bolt nut carefully until the
floor mounting bolt nut is just snug. Cut excess
length from the floor mounting bolt using a
hack saw. Then install the plastic bolt caps (O)
onto the plastic washers (O).
5. Before assembling toilet tank (B) to toilet
bowl (A) check tightness of lock nuts on both
flush valve and fill valve.
6. Assemble toilet tank mounting bolts (C) in toi-
let tank (B) with rubber toilet tank bolt washers
(D) and plastic wing nuts (E). Plastic wing nuts
(E) should be tightened by hand sufficiently to
compress rubber toilet tank bolt washers (D)
and insure water seal.