Banks Power Ford Motorhomes: (Gas ’97 - 05 6.8L V-10, Class-A (20-valve)) Power Systems- PowerPack, Stinger & Git-Kit Systems, (Class-A) '97-05 - Manual (Page 15)

square provided. It is very important to
clean both sides of the board in order
to have a good connection between
the ECU and the Banks OttoMind
module. it is only necessary to clean
the connector fingers. Be careful
not to damage any circuit traces on
the board further inside the ECU.
Reassmeble the ECU case and tighten
the screw.
45.
Orient the module so that its
edges line up with the edges of the
ECU case. If the edges do not line up,
the module is rotated 180 degrees
off. Place the OttoMind module over
the connector, and press firmly to
set the connection. DO NOT FORCE
the OttoMind onto the connector, as
damage may result to either the ECU
or the module. If the module does not
install with firm pressure, check the
orientation and try again.
46.
A portion of the black plastic case
must be cut away to provide clearance
for the Ottomind module. Using figure
8 as a guide, cut away the portion of
the case between the first rib on the
right side and second rib on the left
side, 3 ⁄
4
-inch in from the corner as
shown. A band saw or hack saw works
well for this job. Deburr the edges and
reinstall the ECU in the plastic case,
then reinstall ECU and case in the
vehicle. The one corner screw shown
may be omitted, as it is very difficult
to reinstall. Reattach the electrical
connector to the ECU and tighten the
retaining bolt.
-end, section 4-
Bill of Materials
FIG.#1 COMPONeNT GIT-KIT STINGeR POWeRPACK
1 torQuetuBe, left – – 3
2 TORQUETUBE, Right – – 3
3 y-PiPe – – 3
4 y-PiPe eXtension – – 3
5 dynaflow muffler 3 3 3
6 monster tailPiPe 3 3 3
7 tail PiPe tiP 3 3 3
8 ottomind
(Optional)
– 3 3
9 suPer-scooP – 3 3
10 HOSE, Air duct 4” x 5’ – 3 3
11 connector, ram-air hose – 3 3
12 housinG, air filter – 3 3
13 air filter element – 3 3
14 air inlet tuBe – 3 3
15 heat shield, starter – – 3
16 heat shield, Valve cover – – 3
17 HEAT SHIELD, Tail Pipe Extension 3 3 3
18 heat shield, Blanket – – 3
19 HANGER, Exhaust
(Right Exit Only) 3 3 3
20 (4) mountinG straP – 3 3
96378 v.6.0
15