Banks Power Ford Trucks: (Gas ’04 - 08 F-150 V6 & V8) Programmer- AutoMind Programmer (Ford) - Manual (Page 6)

6
96518 v.6.0
Note: If you have previously flashed
your vehicle with the OttoMind
and made changes to adjustable
parameters, the OttoMind will retain
your most recent parameter selections.
To modify your selections when
reflashing your vehicle again select
‘CHANGE’ instead of ‘KEEP PREVIOUS’
in the adjust options screen.
-IMPORTANT- Verify your vehicles axle
ratio before selecting and entering the
ratio to the OttoMind programmer. The
vehicle axle ratio can be found marked
on a tag bolted to the rear differential.
See Figure 5. An incorrect axle ratio
entry will alter engine R.P.M and
transmission shift points.
7.
Once you have finished modifying
your selected tune, press the ‘ESC’
button to save changes and begin
installing the tune.
all Vehicles
8.
In the ‘Flash Vehicle’ screen, press
the ‘ENTER’ button.
9.
Follow the on screen instructions
and turn the ignition key ‘ON’, but do
not start the engine, when prompted
by the programmer.
Note: The initial tune process may take
up to thirty minutes to complete.
10.
The Banks OttoMind programmer
will begin to upload the Stock tune to
the Handheld and display percentage
of completion. After the completion of
the stock tune upload, Banks OttoMind
will download the selected tune to the
ECM. The Banks OttoMind message
center will display the percentage of
completion.
11.
When the process is complete
the screen will display “Download
Complete, Turn Key OFF, Then Press
ENT.” See Figure 6.
12.
The selected tune is now in the
vehicle. You may drive it now. Please
unplug the programmer before driving.
-END, SECTION 2-
Figure 5 Axle Ratio Tag Bolted on Rear Differential