Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- Banks Navigation For use with Banks iQ - Manual (Page 5)

96838 v.1.0
5
Banks iQ Navigation software comes
ready to install and use in a Micro SD
card.
Before installing the software, it is
necessary to be in the ‘Environment
Select’ menu. Refer to the Banks
iQ manual to navigate back to the
‘Environment Select’ menu.
Remove any personal Micro SD card
installed in the Banks iQ before
inserting Banks Micro SD card with the
navigation software.
caUTioN: The Banks iQ Navigation
program will only be available
when the Micro sD card with the
navigation software is installed
in the Banks iQ. Do not remove
Banks Micro sD card with the
navigation software while the
program is running as this may
cause Banks iQ not to function
properly. Exit the navigation
program first before removing the
Micro sD card with the navigation
software.
Insert the Micro SD card with Banks
Navigation software into the Banks iQ
Micro SD card port. See figure 1 or
figure 2.
After Banks Micro SD card is inserted,
Banks iQ will take a few moments to
read the SD card and display the ‘GPS
navigation’ tab in the ‘Environment
Select’ menu. See figure 3. Press
on the ‘navigation’ Tab to start the
navigation program.
EXiT
To Exit the navigation program and to
return to the Environment select menu,
press the ‘Menu’ button in lower right
corner of the Main map display. Press
the ‘Settings’ button in the Menu select
screen. Press the ‘Exit’ button in the
Settings menu. press ‘Exit’ again when
prompt to do so to confirm.
-EnD, SEcTIon 2-
section 2
iNsTalliNG BaNks NaviGaTioN PRoGRaM
figure 1 Left Side Edge - A5
figure 2 Left Side Edge - A3